In the initial position, the clamping bore axes of the swivel clamp connector joints EN 286.9 are in line with each other and can be swiveled by ±90°. They hold typical construction tubes with full surface contact over the entire cross-section of the bore.
At the screw locations z1, the socket cap screws reduce the bore cross-section for clamping. Adapter bushings EN 290 can be used to reduce the bore cross-sections to smaller diameters.
The screw location z2 serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.
For clamping without tools, the socket cap screws can be replaced by the adjustable levers GN 911.9 listed in the table as accessories.
Specification
Connector clamp
Plastic, Polyamide (PA)
Glass fiber reinforced
Operating temperature
-4 °F to +212 °F (-20 °C to +100 °C)
Color
Black, RAL 9005, matte finishSW
Gray, RAL 7040, matte finishGR
Socket cap screws ISO 4762
Stainless steel AISI 304
Hex nuts DIN 985
Stainless steel AISI 304
Self-locking with polyamide ring
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.392 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: +52(81)2721-4021
All Prices are in Mexican Pesos. Taxes Not Included.
Original design
